176 results found for "roof"
Myrtle Square canopy
...of two beams which transfer the load of the roof to the concrete foundation. For stability, ... up.
We connected the steel girders of the roof to the columns with compression struts ...
Innovationzentrum Spartherm
...we then mounted the glass. In the ridge of the roof, the curved structure is formed by laminated ... to mount from the outside in the ridge of the roof, we worked on an assembly bridge. The bridge ...
Rebuilding the Glass Hall
...elevation on which the construction rests. The roof glass also had to be replaced by hard and ...
Polaris LVNL Bridge
...glass in the facades has been extended to the roof to make the interior space transparent and ... kit seals) except for four glass panels in the roof (as hoisting openings) and the ends (for the ...
Friesland Bank
...load and live load of the adjacent flat glazed roof, which is approximately 28 x 28m². This ... additional dead load from the flat glass roof, not the wind, proved the governing load ...
Fraunhofer Institut
...installation of a structural facade, an atrium roof light and the canopy above the main ... rods by means of Quattro nodes.
The atrium roof light is constructed of ultra light tensile ...
Droogbak
'The main load bearing construction of the roof over this atrium, 26 by 28 meters, ... attic floor, absorb the upward wind load. The roof modules are divided by a secondary stainless ...
Ring Pass
...such as childcare. The construction of the roof in this extension has been made of cardboard ... Nils Eekhout
The roof is fully compliant with the requirements of ...